The EZ Foundation. Done in a Day, Built for a Lifetime.
Our EZ Foundation is a precision-engineered steel pile-cap anchor that replaces traditional concrete footings entirely. No digging, no rebar, no pour, no curing. A two-person crew sets in minutes, without heavy equipment.
Starting at$355per anchor
A pile-cap anchor system.
Four structural steel piles drive down and outward through the cap at opposing angles. That incline geometry combines three forces into a single, solid footing — one that resists gravity, uplift, shear, and moment loads alike. Combined ground penetration runs roughly 16 feet, split to whatever depth combination your soil passes.
- Skin friction — resistance built up along every driven pile.
- End bearing — load carried at the tips, deep below grade.
- Axial distribution — opposing piles lock the cap against uplift, shear, and moment.
Four steps. One day. No crew of ten.
All it takes is a two-person crew, a jackhammer, and hand tools — no excavator, no concrete truck, no crane. Most kits go from marked ground to finished foundation in a single day.
- 01
Mark the layout
Snap a string line and mark each mount location with a tape measure and laser level — right after your 811 utility locate.
- 02
Set the mounts
Drop each mount on its mark and level it with a torpedo level. A tap from a hammer is all the adjustment it needs.
- 03
Drive the piles
A standard jackhammer with a pile-driving adapter sinks the four piles through the cap. No auger, no excavation, no spoil to haul off.
- 04
Build on top
Bolt your column to the cap and raise the kit. Pro tip: assemble the frame onto the mounts first, then drive — near-zero measurement error.
No Concrete. No Excavation.
Driving piles instead of pouring concrete skips the biggest cost and the longest wait on the jobsite.
- No digging, no rebar cages, no concrete pour
- Two-person crew — no heavy equipment or machinery
- Nothing to cure: an immediate, rock-solid build
Set it and Forget it.
Every EZ Foundation component is hot-dipped galvanized steel for long-life protection in all conditions.
- Hot-dipped galvanized steel — corrosion-protected in any climate
- Won't rot, warp, or shrink; impervious to termites
- Non-combustible structural steel
- Maintenance is a once-a-year visual inspection
Four piles, one cap, zero concrete.
The Pile Cap
Precision steel plate with angled pile sockets — the anchor that ties the system together.
4 Structural Piles
Driven down and outward at opposing angles for multi-directional hold.
Tek Screws
Fasten the cap to the piles — the whole connection, no welding on site.
~16 ft In-Ground
Combined pile penetration; split to whatever depth combination your soil passes.
Engineered for your site.
Design capacities are calculated with the working-stress method using refined geotechnical data for friction and bearing. The EZ Foundation is engineered as the footer for the Steel Shade Kits carport, gazebo, and pergola line — with site-specific engineering available where local conditions require it.
Safety: always call 811 to locate buried utilities before driving piles.
Ready to skip the concrete?
Tell us about your site and we'll spec the right kit and foundation — permit-ready, engineer-stamped, shipped direct.